DPA 2028-B-B01 solistimikrofoni, kondensaattori

DPA 2028-B-B01 solistimikrofoni, kondensaattori (695,00)
- DPA 2028 on ammattimuusikon valinta
- Versio: B-B01 wired
- Pro-tason kondensaattori solistimikrofoni
- Luonnolliset vokaalit folkista metalliin
- Monia samoja ominaisuuksia kuin DPA:n lippulaivamalli D:facto 4018VL vokaalimikrofonissa
- Suuntakuvio: superkardioidi
- Äänenpaineen kesto (THD 10%): 160 dB
- 2028 kestää äänenpainetta jopa 139 desibeliä alle 1% säröytymisellä!
- Kierrolle epäherkkä
- Lineaarinen taajuusvaste
- Uusi kapselityyppi

Mikrofonista on saatavilla kolmea kapselityyppiä: langallisen mikrofonin lisäksi samaa kapselia tarjotaan kahtena variaationa langattomia kapulalähettimiä varten.
Muiden valmistajien käsipuloihin sopivat kapseliversiot ovat seuraavat: Shure/Sony/Lectrosonics/Audio-Technica -malleille (B-SL1) ja toinen Sennheiser-yhteensopivana (B-SE2).

One mic allows you to capture true sound and produce an unforgettable show. Effortlessly. The 2028 Vocal Microphone is designed for the unique challenges of live stage performances. It is a flexible handheld vocal mic, which provides transparent, fantastic vocals to performers from a wide range of markets including live, HoW, broadcast, etc. Use it wired or together with your favorite wireless system, either way, just plug it in and hear the vocals shine like never before.

Directional pattern Supercardioid
Principle of operation Pressure gradient
Cartridge type Pre-polarized condenser
Effective frequency response 20 Hz - 20 kHz
Frequency range, ±2 dB, at 12 cm (4.7 in) 100 Hz - 16 kHz. Permanent 3rd order low-cut filter at 80 Hz
Sensitivity, nominal, ±3 dB at 1 kHz 5 mV/Pa; -46 dB re. 1 V/Pa
Equivalent noise level, A-weighted Typ. 22 dB(A) re. 20 µPa (max. 23 dB(A))
Distortion, THD < 1% 136 dB SPL RMS, 139 dB SPL peak
Dynamic range Typ. 117 dB
Max. SPL, THD 10% 160 dB SPL peak
Rated output impedance 150 O
Minimum load impedance 1 kO
Cable drive capability 100 m (328 ft)
Output balance principle Impedance balancing with Active Drive
Common mode rejection ratio (CMRR) > 50 dB at 1 kHz
Power supply (for full performance) 48 V Phantom power (±4 V)
Current consumption Max 2.5 mA
Connector XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Weight 286 g (10.1 oz)
Diameter 48 mm (1.9 in)
Capsule diameter 19 mm (0.75 in)
Microphone length 188 mm (7.4 in)
Maximum output voltage, RMS 9 Vrms; 19 dBV; 28 dBu
Polarity +V at pin 2 for positive sound pressure